Statox 501 PID

Detectable Gases: All Substances of which the potential of ionisation is smaller than 10,6 eV
Measuring programs: 0 – 10, 0 – 100, 0 – 1000, 0 – 10000 ppm
Measuring principle: Photo – Ionisation
Power supply: 5.2 V DC
Operation temperature: -30° – +60°C
Operation with: Statox 503 Control Module
Material Housing, Interface :Cast aluminum, Stainless steel
Protection class: min. IP54

Brand	Compur Monitors
Data Sheet	Statox 501 PID

Gasdetector Statox 501 PID detects VOC Gases and Vapors.
PIDs (Photo – Ionisation – Detectors) detect VOCs (Volatile Organic Compounds) in the ppm range, which other sensor types are unable to monitor, like solvents and fuels.
A PID sensor uses high energy ultra violet light radiation to break gas molecules into radicals, which are discharged while passing a condenser. The discharge current increases proportional to the number of molecules, ie. the gas concentration. The standard Statox 501 PID will detect all substances with a ionization energy below 10,6 eV.
A magnetic pin gives access to simple parameter setting and calibration menu. A multi – color LED signalises the status of the system.
The Statox 501 PID voltage output signal is similar the the signal of a catalytic sensor. The Statox 503 control module displays the measured value and provides an analog output and 3 powerful relay outputs for alarm devices or pcs.

Additional information

Brand	Compur Monitors
Data Sheet	Statox 501 PID

There are no reviews yet.

Be the first to review “Statox 501 PID”

You must be logged in to post a review.